I have a flat piece of 16ga steel (12"x18")that I need to have four bends put in and cut down. I am working on an arcade game and need to re-make a mounting plate that holds all of the components of the power supply. Example power supply seen here:
The metal brake my friend has is to big and will not do the two opposing 90 degree bends so close to each other as to allow the component section to sit 1/2" above the two mounting flanges I need on both sides. Anybody out there know someone that can do this for a reasonable fee?
Thanks in advance.
The metal brake my friend has is to big and will not do the two opposing 90 degree bends so close to each other as to allow the component section to sit 1/2" above the two mounting flanges I need on both sides. Anybody out there know someone that can do this for a reasonable fee?
Thanks in advance.
