SBR question about bren 805

[maxmayhem]

[h=2]I know I am late to the party on this one but bren 805 sbr question...[/h]

i want to sbr a bren 805 with 922 r compliance (please omit languishing about 922r legaility, ignoring it, and the atf in general--already been down that path a hundred times)

Dan haga has the stock and adapter
Muzzle device obtained anywhere (muzzle attachments)
Dan Haga has a pistol grip (pistol grip)


US made magazine count for 3 parts(magazine bodies) (Follower) (Floor Plates)


No more than 10 from this list does not seem possible unless it already has US parts:
(1) Frames, receivers, receiver castings, forgings, or castings.
(2) Barrels.
(3) Barrel extensions.
(4) Mounting blocks (trunnions).
(5) Muzzle attachments.
(6) Bolts.
(7) Bolt carriers.
(8) Operating rods.
(9) Gas pistons.
(10) Trigger housings.
(11) Triggers.
(12) Hammers.
(13) Sears.
(14) Disconnectors.
(15) Buttstocks.
(16) Pistol grips.
(17) Forearms, handguards.
(18) Magazine bodies.
(19) Followers.
(20) Floor plates​

 

[KJQ6945]

Does anyone make a drop in trigger for it? That could get you up to about 9 parts, then put a muzzle device on and your set.
Good luck!

 

[maxmayhem]

i dont think this is correct- i would have to replace nine other parts

Does anyone make a drop in trigger for it? That could get you up to about 9 parts, then put a muzzle device on and your set.
Good luck!

 

[KJQ6945]

i dont think this is correct- i would have to replace nine other parts

A drop in trigger could possibly count as up to 5 parts, items 10 through 14, on your list. 3 more for the magazine. You’ve located a US made stock, pistol grip, and flash hider. That’s 11 parts.

 

[Tactically Fat]

https://www.cooltools.us/Design-Stamp-USA-Made-4mm-p/pun-674.htm

 

[maxmayhem]

ok sounds good- makes sense- disconnector sear, etc--didnt think of it that way

A drop in trigger could possibly count as up to 5 parts, items 10 through 14, on your list. 3 more for the magazine. You’ve located a US made stock, pistol grip, and flash hider. That’s 11 parts.

 

[maxmayhem]

doesnt work on aluminum or steel "U[FONT=&quot]se to stamp the image into brass, copper, bronze, silver or clay"[/FONT]

https://www.cooltools.us/Design-Stamp-USA-Made-4mm-p/pun-674.htm

 

[Tactically Fat]

doesnt work on aluminum or steel "U[FONT=&amp]se to stamp the image into brass, copper, bronze, silver or clay"[/FONT]

If you hunt around, you can absolutely find stamps that'll work for steel parts. ;-)