SA cylinder bushing tool

The #1 community for Gun Owners in Indiana

Member Benefits:

  • Fewer Ads!
  • Discuss all aspects of firearm ownership
  • Discuss anti-gun legislation
  • Buy, sell, and trade in the classified section
  • Chat with Local gun shops, ranges, trainers & other businesses
  • Discover free outdoor shooting areas
  • View up to date on firearm-related events
  • Share photos & video with other members
  • ...and so much more!
  • Leadeye

    Grandmaster
    Rating - 100%
    4   0   0
    Jan 19, 2009
    36,693
    113
    .
    Had to fit a replacement cylinder bushing in one of my SA revolvers, somewhere down the road it was fitted with one that was bored off center which prevented easy chambering of two cylinders. The replacement was too large in both OD and length. Not having a lathe I was able to use this combination and my drill press to solve both problems. The wing nut held the bushing solid so I could use various grits of sandpaper to reduce the diameter in the drill press. Later it held the bushing reasonably square to a sandpaper covered flat surface which allowed me to reduce it's length. The Bisley is now shooting 38-40 again with no issue.
     
    Top Bottom