Normally, when I set up a new AR 15 bolt, I like to remove the ejector and install a chrome silicon ejector spring. Well, this bolt was mounted in the Sinclair Bolt Vise and I was unable to drive the roll pin through from the top to remove the ejector and spring. Went to the internet in search of a solution. Heat the bolt, penetrating oil, drill the roll pin out, etc.
Finally, thinking outside the box, or in this case, with the box turned over. Simply turn the Sinclair Bolt Vise upside down, insert the roll pin punch into the bottom side "exit hole" and drive the roll pin out. So simple, but could save someone some frustration removing a difficult ejector roll pin.
Finally, thinking outside the box, or in this case, with the box turned over. Simply turn the Sinclair Bolt Vise upside down, insert the roll pin punch into the bottom side "exit hole" and drive the roll pin out. So simple, but could save someone some frustration removing a difficult ejector roll pin.