as far as the Mr. Bardwell letter, it's on just about every NFA forum. It's about as clear as mud when it comes to answering the question regarding Form1
I have contacted my trust attorney on this and am waiting on a response. But it was his understanding that on a form1 the listed manufacture...
FWIW were talking about a $180K Laser. It measures .005"/.007" deep and could have cut thru like butter.
But you are right the vast majority can barely scratch the surface
There are so many reasons I did my Form1 online....
This is just another situation this is a better idea. and when approved you get your stamp via email same day
shooting with both eyes open take the FOV limitations/acquisition time out of the equation.
If they made one in a Viper or Diamondback I might be interested....
A few weeks ago I got a Ruger Gunsite Scout in .308
I ordered a Leupold FX-II 2.5x28 IER scout for it from Optics Planet. I mounted it with Warne Maxim steel rings.
I honestly dont remember spending much tome looking down the scope before mounting. Well after mounting I saw the horizontal...
Thanks and like HOP said I could have cut clean thru if I wanted to. The engraving is actually about .005"/.007" deep (used a 50w fibre laser)
It is my understanding that as the manufacture (actually my trust) I can make changes while destroying the old parts before beginning the new ones.
The...
Hi everyone this is my first post here and I thought I would share my most recent build....
Its a 1"x6" .22 can.
4.2oz
Tube in tube design
12 baffles
All Titanium
Glass bead blast finish may do a DIY OD Green anodize
Spend the last 4 months designing it in solidworks but didn't get serious...