Thanks for the idea. I'll see if I can create something like that.
The take down lever is rounded off on the bottom so it tends to slide across the spring instead of pushing down.
Here are more pics. I can try to take any picture needed.
I have tried using a 1/16 punch to push the spring back then quickly slide the lever in. I haven't been able to pull this off the plunger springs back before I can get the lever in place.
Sorry all the pics went sideways. I'm not sure...
Hello, I got my self into a little jam and I was hoping for some advice.
This is an old Galef/Beretta companion single barrel folding shotgun. I recently got this and it was about 20 years over due for a good deep clean. I'm having problems with the re-assembly.
The picture should help, the pin...
I'm with you on doing a project. I keep tossing around ideas, but nothing has stuck yet. Was part of one back in the day before I found it it was a scam.
How is the ROI on Bitcoin private. I have an old Antminer S2 I could throw into service. Probably eat more power cost that it's worth though.
I'm with you there. I started out mining when Btc was around 650, it quickly dropped to 350 durning most of my mining. I learned a lot, but wish I would have just stuck all the money from mining into btc, and sat on it.
Ended up getting burnt out and walking away for a couple years.
Great, thread wish I would have found it sooner.
I've been swing trading. Currently have NEO, ETH, LTC, and UBQ. Really like UBQ hope it takes off but its been slow.
What's your guys thoughts on Charlie Lee, seems like there is alot of craziness around him right now. Hope it doesn't effect...