If the projectiles are plinking grade then you will still get plinking grade accuracy from a 1:7/1:8 barrel.
With that said, I use Berger 52gr and 55gr target bullets and in both a 1:7 and 1:8 barrels am consistently get .5-.75" groups with stick powder.
Looking for a good to excellent condition Ruger RPR in .223
Daughter is looking to try some longer range shooting and thought this would be a good rifle to look for.
Please let me know.
Pants are new as show: black, and battle brown. Size 40x30, $45 each
Black was tried on only to realize they don’t fit. Battle brown never made it out of the bag.
Two pack short sleeve utili-t tshirts. One black one tan both xxl. $35 for the pair.
Any questions please ask.
Thanks
New Lee load all 2 in 12 gauge.
Misplaced instructions, one mounting screw, and two wing nuts. Otherwise complete with box. Parts as pictured.
700 CCI 109 primers (same as 209, they have a different plating)
100 Winchester 209
274 Remington STS 209
$100 ftf takes all
Located in NWI...
No longer have any blackpowder guns so looking to move these items along as a lot to someone who could actually use them.
CVA powder flask
Powder measured (0-30)
Nipple wrench
Straight lines capper
TC Bore Butter
CVA case
1# can of Hodgdon Triple Se7en (FFG)
1# total Goex FFG
1# Goex FFFG
5.0...
GSL technologies out of Michigan holds the patent on the bi lock and sells plenty. Also, there’s no drought of Gemtech branded muzzle devices at Joe Bob outfitters or midway just to make a few
You don’t clean the area after doing this? Poor cleaning / storage procedure is what gets people in the rusted SS boat to begin with. I didn’t think it was needed to state that cleaning after the fact was needed. And the 0000 has worked better and easier for me in the past than the lead remover...
At this point all you’re describing is a standard A2 front sight on a whatever length barrel you want. Either 10.5, 11.5, 14.5, 16, or 20 inch, or whatever the hell else barrel length is made now a days, just pick the manufacture that fits your budget with the A2 installed from them. Gas port...