Did some work on a Glock

[AllenM]

Trigger and chrome parts were done by the owner. I did the slide mill work and refinished slide and magwell to match.

Revel cut on slide
Also shows a hole that I drilled and tapped for a scope base





Front serrations around lettering





Some cosmetic cuts on top



Done

 

[IndyGunworks]

I like it alot.... looks like it could be robo cops gun.

 

[AllenM]

I like it alot.... looks like it could be robo cops gun.

Thanks

 

[horsehaulin]

Looks great! Do any work on M&P slides?

 

[copo]

That really looks good.

 

[AllenM]

Looks great! Do any work on M&P slides?

Depends on what you have in mind, I am limited in my ability

 

[Ruffnek]

Looks amazing and the front serrations look like something from the factory!How much do you charge for this type of work?Turnaround time?Is there a purpose for cutting out at the top front of the slide it is it purely cosmetic and weight reduction?

 

[AllenM]

Looks amazing and the front serrations look like something from the factory!How much do you charge for this type of work?Turnaround time?Is there a purpose for cutting out at the top front of the slide it is it purely cosmetic and weight reduction?

Thanks, guess I should have broke this out. the hole in the top of the slide is factory on a 34, it is for weight reduction all I did were the thin line cuts.
As for cost it's a case by case scenario.

 

[Trigger Time]

Nice work Allen!

 

[sensor5]

Allen, I was going to send you a PM, but am unable to because I have less than 50 posts. I have a Glock 30 slide I would like to have milled (corners rounded and front serrations) and refinished in cerakote black. Are you accepting work? Thanks

 

[AllenM]

Allen, I was going to send you a PM, but am unable to because I have less than 50 posts. I have a Glock 30 slide I would like to have milled (corners rounded and front serrations) and refinished in cerakote black. Are you accepting work? Thanks

You can email me at amoore@diamond-collision.com we can talk about it

 

[WebSnyper]

Allen, I was going to send you a PM, but am unable to because I have less than 50 posts. I have a Glock 30 slide I would like to have milled (corners rounded and front serrations) and refinished in cerakote black. Are you accepting work? Thanks

You will definitely like it... here's a pic of something similar.

Standard Glock 23 on the left, Allenized Glock 19 on the right with rounded out slide: