Hi Power extractor

[Slow Hand]

So, I had an issue at the range today and long story short; my Browning HP extractor ‘has left the chat’. I see a few variations available. Has anyone ever found one to be better than the other; or better than a factory one? I never had any issues with the original it if I’m stuck replacing it, might as well spend a bit more for a better one. I know some guns, like Ruger MK series .22’s work better with aftermarket extractors. Just curious if the same applies to the Grand Puissance, or however those goofy Belgians say it…

 

[KokomoDave]

I used the C&S extractor. I stay the heck away from MIM parts!!

BHP CNC Extractor for 9mm - Cylinder & Slide - Handguns parts and accessories

This extractor has been slightly modified to better fit the Browning Hi Powers chambered in 9mm. It is CNC machined from alloy steel that is suited for extractors. The extractor is heat treated to RC 45-50. All extractors are checked for proper heat treatment. Fitting is required so installation...

cylinder-slide.com

 

[WebSnyper]

Following. Luckily both my SA-35'S did not have the extraction issues of the early serial numbers. If I did replace mine it would either be cylinder and slide or apex tactical.

 

[Slow Hand]

I used the C&S extractor. I stay the heck away from MIM parts!!

BHP CNC Extractor for 9mm - Cylinder & Slide - Handguns parts and accessories

This extractor has been slightly modified to better fit the Browning Hi Powers chambered in 9mm. It is CNC machined from alloy steel that is suited for extractors. The extractor is heat treated to RC 45-50. All extractors are checked for proper heat treatment. Fitting is required so installation...

cylinder-slide.com

Heck, I thought they had closed down!

 

[Slow Hand]

Following. Luckily both my SA-35'S did not have the extraction issues of the early serial numbers. If I did replace mine it would either be cylinder and slide or apex tactical.

Not having extraction issues before today. As of now, that big empty or is causing me some issues…

 

[Slow Hand]

I had a Misfeed with some handloads and I guess it shoved the bullet back into the case and jacked up
Pressure.

It’s kind of interesting because you can see the offset like how the case head was still locked into the breech face when the barrel dropped down and dumped the pressure into the extractor groove.

It’s kind of funny how you can look at something and see it happening in slow motion when you somewhat understand how things work…

 

[Hookeye]

I may have a HP extractor around, have to check