Engrave it with what ever you put in line 4a, and your city and state.
Engrave it with what ever you put in line 4a, and your city and state.
Subpart G--Registration and Identification of Firearms
Sec. 479.102 How must firearms be identified?
(a) You, as a manufacturer, importer, or maker of a firearm, must
legibly identify the firearm as follows:
(1) By engraving, casting, stamping (impressing), or otherwise
conspicuously placing or causing to be engraved, cast, stamped
(impressed) or placed on the frame or receiver thereof an individual
serial number. The serial number must be placed in a manner not
susceptible of being readily obliterated, altered, or removed, and must
not duplicate any serial number placed by you on any other firearm. For
firearms manufactured, imported, or made on and after January 30, 2002,
the engraving, casting, or stamping (impressing) of the serial number
must be to a minimum depth of .003 inch and in a print size no smaller
than 1/16 inch; and
(2) By engraving, casting, stamping (impressing), or otherwise
conspicuously placing or causing to be engraved, cast, stamped
(impressed), or placed on the frame, receiver, or barrel thereof certain
additional information. This information must be placed in a manner not
susceptible of being readily obliterated, altered or removed. For
firearms manufactured, imported, or made on and after January 30, 2002,
the engraving, casting, or stamping (impressing) of this information
must be to a minimum depth of .003 inch. The additional information
includes:
(i) The model, if such designation has been made;
(ii) The caliber or gauge;
(iii) Your name (or recognized abbreviation) and also, when
applicable, the name of the foreign manufacturer or maker;
(iv) In the case of a domestically made firearm, the city and State
(or recognized abbreviation thereof) where you as the manufacturer
maintain your place of business, or where you, as the maker, made the
firearm;
Sorry that's wrong. Box 4a on a Form 1 is the original manufacturer of the lower and their city, state. For example, if you were using a Spike's lower, this box should read Spikes Tactical Apopka, FL. You would NOT want this info engraved AGAIN on your lower.
OP, you want whatever you put as the applicant name from box 3b as well as the city and state from the same box.
Ok, I see what you guys are saying. I will check my form. It was Eform Trust so I assume I will put full trust name and city,state.
Sorry that's wrong. Box 4a on a Form 1 is the original manufacturer of the lower and their city, state. For example, if you were using a Spike's lower, this box should read Spikes Tactical Apopka, FL. You would NOT want this info engraved AGAIN on your lower.
OP, you want whatever you put as the applicant name from box 3b as well as the city and state from the same box.
Here's the ATF regs on this (from 27CFR479.102):
The caliber and serial # is already there, so you need to mark your name and city, state.