Let's see the cool stuff you make! Official "show off thread"

[Frosty]

These were the two I poured yesterday. These are the last two, so no more pics of these.
The left one was a request from the Mrs.






View attachment 350876

Mrs. Lpherr has good taste!

 

[Frosty]

A small drop point in 1084. Made it fancy with scales poured by @Lpherr that I segmented with G-10 liners and spalted maple.

 

[Lpherr]

A small drop point in 1084. Made it fancy with scales poured by @Lpherr that I segmented with G-10 liners and spalted maple.
View attachment 350920

View attachment 350921 View attachment 350922

That came out nice. Nice combination too.
It must have a Hemi, because it's sweet.

 

[Frosty]

That came out nice. Nice combination too.
It must have a Hemi, because it's sweet.

Thank you! I really like the contrast, helps that the scales polish up so nicely

 

[Frosty]

Got the sheath done for the little drop point

 

[SmileDocHill]

2 different drawer pulls for my desk drawers. The bottom looks better but requires drilling 2 holes in the lid. The top: what's shown only works as a drawer pull and the attachment of the lid to the drawer is a different thing all together.

 

[Lpherr]

I didn't make it, but I made it pretty.

I did a full brake service (calipers, rotors and pads) on the truck since the one wheel has been grinding badly. This is the result of all the metal being ground off the rotor and pad backing plate.




That is unacceptable, so I had to add some pretty to it.
Ten minutes on the buff jack.

 

[Gabriel]

While not particularly practical, I got this done this morning...