Ok i'm sure this has probably all ready been talked about , but i just ran into it this weekend . I had bought a bag of 250 mixed brass, when i started reloading i came to one the primer would not go -- so i removed the brass and noticed the primer hole was smaller then the primer . I remembered reading some ware that this was happening ,so i started sorting through the brass and came up with about 100 small primer brass. Heres my question ,my load data books are only a couple years old ,but they dont say any thing about this change -
#1 when did it start ?
#2 are all manufactures going to do this ?
#3 Is there a powder change -more powder -less powder ?
#1 when did it start ?
#2 are all manufactures going to do this ?
#3 Is there a powder change -more powder -less powder ?