BurninBrass
Marksman
SOLD AND GONE
Location: Vigo County
No Pictures as I am not currently at home to post them.
I have an AR-15 that I am looking to sell. It was assembled this summer and tested for function with a total of 120 rounds fired. It was then cleaned and lubed and put in the safe.
It was assembled from a stripped lower (Rock River 5.56 marked), lower build kit (Palmetto), and complete upper (Palmetto). I also purchased the M-16 BCG and charging handle from Palmetto. The stock, grip, trigger guard, handguard, and vertical foregrip are all Magpul MOE. The flip-up rear sight is a Magpul MBUS Gen 2. I will include 2 30 round C-Products aluminum mags loaded with 60 rounds of brass 223.
There is little to no visible wear on any of the parts as they were all purchased new by myself. There is, however, a small amount of play in the fit from the upper to the lower that is not uncommon and has zero effect on the function. This can be corrected with an accuwedge or small O-ring.
Details on all the parts below (click for link):
Stripped Lower Receiver
Lower Build Kit
Complete Upper
Bolt Carrier Group
Charging Handle
Backup Sight
Location: Vigo County
No Pictures as I am not currently at home to post them.
I have an AR-15 that I am looking to sell. It was assembled this summer and tested for function with a total of 120 rounds fired. It was then cleaned and lubed and put in the safe.
It was assembled from a stripped lower (Rock River 5.56 marked), lower build kit (Palmetto), and complete upper (Palmetto). I also purchased the M-16 BCG and charging handle from Palmetto. The stock, grip, trigger guard, handguard, and vertical foregrip are all Magpul MOE. The flip-up rear sight is a Magpul MBUS Gen 2. I will include 2 30 round C-Products aluminum mags loaded with 60 rounds of brass 223.
There is little to no visible wear on any of the parts as they were all purchased new by myself. There is, however, a small amount of play in the fit from the upper to the lower that is not uncommon and has zero effect on the function. This can be corrected with an accuwedge or small O-ring.
Details on all the parts below (click for link):
Stripped Lower Receiver
Lower Build Kit
Complete Upper
Bolt Carrier Group
Charging Handle
Backup Sight
Last edited: