How "on" is your AR in regards to windage?
At, say 100 yards, how close to the center line of the rear site is zero?
I am turning a budget upper into a dissipator.
Pinning the FSB, I shifted it about .025" from dead on. It is putting me off about 4.5 moa, about 9 clicks.
I used this calculator to figure that out: Sight Correction Calculations
I'm I being too picky, or are your ARs zeroed at or near the center line?
I prefer shooting irons, but I don't want to go OCD over it. I only put in one taper pin at this point, and have some oversized ones, so I have some wiggle room.
At, say 100 yards, how close to the center line of the rear site is zero?
I am turning a budget upper into a dissipator.
Pinning the FSB, I shifted it about .025" from dead on. It is putting me off about 4.5 moa, about 9 clicks.
I used this calculator to figure that out: Sight Correction Calculations
I'm I being too picky, or are your ARs zeroed at or near the center line?
I prefer shooting irons, but I don't want to go OCD over it. I only put in one taper pin at this point, and have some oversized ones, so I have some wiggle room.