diy projects ar/ak

[silentvoice71]

Well ive got several ar lowers done but this one is my crown!

And heres the ak

Most of the ak was done at a friends because of the welder.

 

[T4rdV4rk]

How many hours would you say you have into that AR lower?

 

[silentvoice71]

Well now that i have a good quick way to do it i can do one if i dont stop a keep workin in maybe 6

 

[silentvoice71]

Here it is all painted and on my spr build

 

[spearheadersarge]

Something not lined up on the safety hole? Riveting looks good. What kind receiver? Pre-bent? Heat treated?

 

[silentvoice71]

Its all good. Prebent non heat treated its from ak builder. Im gonna pick up all the stuff to build them so i dont have to drive an hr to a buddies to build it. My next build i think is gonna be a 74 kit

 

[spearheadersarge]

Used some older Tapco flats from a ways back, they looked fabulous after bending but the holes were a little off. Had to do a lot of trimming on the ends as well. They are both frankenbuilds so I'm not real worried about it. They will put down range just fine!

 

[silentvoice71]

To be honest some of the builds ive seen on the interwedz.... These things dont have to be at all perfect