DIY Stippling Thread.

[lawrra]

I know some of you stipple your own roscoes so let's see them! Here's my G26 and G19 I attacked with a $13 wood burner from Walmarts just this week. Feels pretty good. I used a chisel tip for the most part, and worked in a fine point in some areas.

 

[bobjones223]

Here is my TCP. This was my first stipple job. It was also my first dehorning and Cerakote project. All in all I think it turned out good.

 

[Indy574]

Here's mine.

 

[bobjones223]

Here's mine.

What did you use to get that sand pattern? I like it just not sure how you did it.

 

[Indy574]

I used the sharp pointed tip with a lighter touch so I didn't embed too deep.

 

[Trigger Time]

What did you use to get that sand pattern? I like it just not sure how you did it.

You just overlap and keep sticking it.

 

[Trigger Time]

I like the slide cuts on that GLOCK. Is that sniper grey?

 

[Indy574]

I like the slide cuts on that GLOCK. Is that sniper grey?

Tungsten cerakote. Here are the cuts along the top of the slide.

 

[N8RV]

You guys inspired me. I had a couple of old Gen 2 Glock 17s in the safe for students to use, and they're pretty worn slick on the frames. So, why the heck not?

I made some boo-boos for sure, but I learned a lot on this first one. I'll play around with a PMag a little more before I tackle #2 tomorrow.