Not a putdown. Just stating fact.
Not a putdown. Just stating fact.
So you got tired of beating it off?!?Frankly, if I have gotten to the point that I am using heat to get the gas cylinder off I think I would decide not to worry about it. You can strip the rifle down to clean while leaving it on.
Yes, I may have to try beating it on to see what that is like.So you got tired of beating it off?!?
Don't sweat it @Cameramonkey ... facts just don't seem to matter to that thin-skinned one ... it's his way or the highway ... he dishes it out, but doesn't like it when it's given back. I tend to skip over what he writes, unless I'm in a jocular mood ... then his writing is mildly tolerable.Not a putdown. Just stating fact.
Don't sweat it @Cameramonkey ... facts just don't seem to matter to that thin-skinned one ... it's his way or the highway ... he dishes it out, but doesn't like it when it's given back. I tend to skip over what he writes, unless I'm in a jocular mood ... then his writing is mildly tolerable.
I dont think he is the one who claimed to be all knowing with 40 years of experience.So what knowledge and experiences on removing a Garands gas cylinder has your vast knowledge brought to this thread again?
That stainless gas cylinder is kinna tough.I admit I have no experience with a Garand, only my experiences with many things mechanical. I have worked on many items that 40 years ago did not require any more than a wrench, but 40 years later needed some extra persuasion of one kind or another. I simply put the idea out there that to me seems the least risky of further damage than beating.
I never posted your embellishment of "All Knowing" but thats what you do to make your points seem valid. I have better than 40 years thank you.I dont think he is the one who claimed to be all knowing with 40 years of experience.
What are the odds it still has a WW2 undersized barrel on it.OP, do you have a saw cut gas cylinder? If so you need to remove the front sight first. Google "garand saw cut gas cylinder" to see a picture of what I am talking about
Maybe, But I need to find the other video. It was on the ordinance departments methods for repairing war materials, it showed a depot in Japan (I think) where they were repairing garands from Korea.
I understand that, me personally have yet to see a saw cut that cant be tapped off without loosening the sight with a non marring hammer.It can have a cut gas cylinder without undersized WWII barrel. Many match shooters use these today for the tight fit
And to make it even easier, buy some canned air. as soon as you are finished heating the cylinder, turn the can upside down and spray liquid onto the tube and it will freeze the tube and make it shrink.
Careful not to get the liquid on your skin. Instant frostbite.
Interesting, im aware what they were forYes, have seen many. . They were for undersized barrels, if you put one on a normal size barrel it will be impossible to remove unless sight screw is loosened first.