Trying to get up and rolling here, I have the PTX insert and bullet feeder die in the next station. When setting up the PTX with the powder funnel is the powder funnel ram supposed to top out?
I am going back in forth in adjusting the height of the die and then the screw on the bottom that adjusts the amount of bell and getting nowhere.
Vids say it should not top out but then I can not get enough bell on the case.
I am going back in forth in adjusting the height of the die and then the screw on the bottom that adjusts the amount of bell and getting nowhere.
Vids say it should not top out but then I can not get enough bell on the case.