installing sling mounts on 10/22 synthetic stock

[tgent]

Does anyone have any advice on how to install sling mounts on a 10/22 with synthetic stock ?

 

[IndianaWoodsman]

The one I have seen was a factory-job. They used a fine-thread stud on the forearm, so the the nut for the stud was on the inside of the stock with a washer on both sides of the stock. The rear was just a pilot hole and a standard lag-threadded stud screwed into it.

 

[IndyGunworks]

what kind of sling mounts... there are several differant types that attach in differant ways... you might have to drill and then epoxy in... or just drill a pilot hole and thread it in.... pics might help.

 

[repair]

I have a syn stock that you can have that already has the factory mounts.

 

[tgent]

Thanks to everyone for responding. I was trying to post a picture, but for some reason I am not able. I am not looking for any type of mounts in particular, just looking for a way to attach a simple, basic sling. I think that I can buy a barrel band with a mount already attached, so that would take care of the front mount. I am more concerned about the butt stock. Because of the hollow plastic I don't think any type of screw would be very secure.
Thanks a lot repair for the offer. Would you be looking for some type of compensation or is this just free and clear. Either way I am interested. Thanks again everybody.

 

[repair]

it's free...... but if you want to give me 1000.00 for it that good too.

 

[tgent]

Great I'll take it (for free that is ). I'd like to set a time and place to pick up if not too far. I tried to PM you but I guess I can't PM anyone until I have at least 10 posts.

 

[repair]

I just sent you an email