Hi guys and girls;
Hey, I was reading a post about light firing pin strikes the other day and since I was at the range just the other day I decided to check my fired primers on my 9mm carry gun and I noticed that they (seemed) to be light strikes (small indents), so I got out my magnifier and took a closer look at them and discovered that high pressure of the standard 9mm factory rounds were actually swelling the primer into the firing pin hole and then slicing off part of the primer when the barrel unlock, leaving a small piece of primer brass in the hole.
After close examination I could see there was a very sharp edge on the entrance of the firing pin hole that was shearing off this brass, so I carefully and gently deburred the edge with a drill bit.
My thinking is that those chips might add up and clog the firing pin possibly causing lite strikes in the future.
I'll have to wait until I go to the range again to see if it helped.
If you see a bunch of brass chips in the slide, this might be what is causing it.
Hey, I was reading a post about light firing pin strikes the other day and since I was at the range just the other day I decided to check my fired primers on my 9mm carry gun and I noticed that they (seemed) to be light strikes (small indents), so I got out my magnifier and took a closer look at them and discovered that high pressure of the standard 9mm factory rounds were actually swelling the primer into the firing pin hole and then slicing off part of the primer when the barrel unlock, leaving a small piece of primer brass in the hole.
After close examination I could see there was a very sharp edge on the entrance of the firing pin hole that was shearing off this brass, so I carefully and gently deburred the edge with a drill bit.
My thinking is that those chips might add up and clog the firing pin possibly causing lite strikes in the future.
I'll have to wait until I go to the range again to see if it helped.
If you see a bunch of brass chips in the slide, this might be what is causing it.