Manurhin MR38

[CCPLuvr]

I did notice there's some creep in DA once the cylinder has locked on the chamber. I'll probably take it apart and find what's dragging and smooth it out. Otherwise the trigger is very nice...

 

[CCPLuvr]

I'm playing with loading Zero 148gr HBWC and WST powder right now. Once a good load is found I'll post some pics.

 

[CCPLuvr]

I found the mainspring screw can be almost completely backed out, just enough contact to prevent the spring from shifting, and there's no issues lighting off Winchester primers. I've got the single action down to about 2.5 lbs, it's to light for me so I'll bump it up a little. But, doing an inspection during the teardown for its first bath, I found drag marks where the hand goes through the frame window. Couldn't find any other out of the ordinary wear so this must be where I'm finding a little creep in DA.

 

[CCPLuvr]

This is a phenomenally accurate revolver though... it hits right where it's pointed.

 

[qwickwire]

Nice revolver. I wish there were more on the US market or that someone would figure out how to import more of them.

 

[CCPLuvr]

The Nill grips finally showed up yesterday. They fill the hand and allow for a higher grip on the gun, much better...

 

[CCPLuvr]

 

[CCPLuvr]

Accuracy is quite impressive with this revolver. Here's 10 shots at a 50' slow fire B2 target, the pistol was resting on the bench. I need some new glasses that allow me to actually see the front sight...

 

[CCPLuvr]