Specification :
* STEREO 4 Ohm POWER 2x65W
* MONO BRIDGEABLE 2 Ohm 1x160w
* MONO POWER N/A, FREQUENCY RESPONSE (-3 dB) :10 Hz - 25 kHz
* SIGNAL TO NOISE RATIO :- 105 dB A WEIGHTED
* DISTORTION @ RATED OUTPUT :< 0.05% THD + N
* damping FACTOR @ 100 Hz : > 125
* INPUT SENSITIVITY :150 mV - 2.5 Vrms
* IDLE CURRENT :1 Amp
BUILT IN CROSSOVER HIGH PASS, LOW PASS, ALL PASS BOTH ON INPUT AND ON OUTPUT
When sound quality is your most important criteria, choose an SQ MMATS amplifier which features the same high performance output topology as esoteric home equipment.
Toshiba audio-grade outputs
High current connectors
Independent gain controls
24db variable crossover
These are still the best SQ amps out there even though this series is not made any longer. AMP works fine, I guarantee it works. obviously its used though so that goes without saying.
THE mmats amps were always rated at 12.5 volts which means they do well over the rated power with more volts. They were always underrated.
100.00 Located in NWI
* STEREO 4 Ohm POWER 2x65W
* MONO BRIDGEABLE 2 Ohm 1x160w
* MONO POWER N/A, FREQUENCY RESPONSE (-3 dB) :10 Hz - 25 kHz
* SIGNAL TO NOISE RATIO :- 105 dB A WEIGHTED
* DISTORTION @ RATED OUTPUT :< 0.05% THD + N
* damping FACTOR @ 100 Hz : > 125
* INPUT SENSITIVITY :150 mV - 2.5 Vrms
* IDLE CURRENT :1 Amp
BUILT IN CROSSOVER HIGH PASS, LOW PASS, ALL PASS BOTH ON INPUT AND ON OUTPUT
When sound quality is your most important criteria, choose an SQ MMATS amplifier which features the same high performance output topology as esoteric home equipment.
Toshiba audio-grade outputs
High current connectors
Independent gain controls
24db variable crossover
These are still the best SQ amps out there even though this series is not made any longer. AMP works fine, I guarantee it works. obviously its used though so that goes without saying.
THE mmats amps were always rated at 12.5 volts which means they do well over the rated power with more volts. They were always underrated.
100.00 Located in NWI
Last edited:
