Would you rock this piece of INGO on your AR

[bwframe]

I'd put it on the steel gun. Lots of exposure there.

 

[cubbetm]

I'm in

 

[edporch]

No.
I would just rather have a plain one.

 

[Gadgetmonster]

Looks like a dash panel from a 1977 Ford pick up to me. Steering column on left side with gauges, am radio and heater controls in the middle, glove box on the right. No? Show me this thing on an AR.

 

[GunSlinger]

I'd switch mine with one.

 

[TJ Kackowski]

I would if you oriented the logo and the flag correctly....like so it's not upside-down when the port was open. (normally the engraving is on the inside of the cover)

Good point! I rescind my vote unless the cover is etched on BOTH sides ... I'm no part time supporter! Ahhhhh, who am I kidding? I'd buy one either way.

 

[bmbutch]

I'd have 1 on an AR, likely each of them.

 

[jd4320t]

Any chance of a matching INGO lower sometime?

This.

 

[Birds Away]

Heck, I can't even get a sticker. What's the chances of actually getting one of these?

 

[JollyMon]

Heck, I can't even get a sticker. What's the chances of actually getting one of these?

This.

 

[Indy_Guy_77]

IF I had an AR - and IF it was etched to have that view when it was open - then yes, I'd absolutely seriously consider it.

 

[wsenefeld]

No, never bothered getting an engraved one in the past because I'd rather not have to disassemble my upper and re-zero just for a dust cover.

 

[cosermann]

... I'd rather not have to disassemble my upper and re-zero just for a dust cover.

The upper doesn't typically have to be disassembled to replace the dust cover unless there's something unusual about your setup.

 

[Sgtusmc]

For those unable to get on the INGO merch page, there is a pixel in the lower right hand of the page you need to find and click to enter.

 

[calcot7]

Sure, why not, I have the INGO license plates and decals/stickers on my vehicles and other stuff. How about an INGO back plate for Glocks?

 

[shooter521]

If oriented correctly, I would do it on more than one gun. Also love to have 'em to sell at the shop!

 

[wsenefeld]

The upper doesn't typically have to be disassembled to replace the dust cover unless there's something unusual about your setup.

How does it not? To slide the pin out that holds the door to the upper receiver, you need to remove the barrel nut.

 

[Lep36]

Put me down…

 

[jimbobcooters]

yes

 

[indiucky]

Put me down…

"No Ol' Yeller!!!! I can't...I just can't"