17 squirrel
Shooter
- May 15, 2013
- 4,427
- 63
A just as good as one!Factory installed? If so, which manufacturer?
A just as good as one!Who?
I have a Esab 1250 Plasma Cutter, it will make short work of getting the lockring off.
Not my place to sayWho?
You need to make a trip to your local grocery store and pick up a 6 pack of MAN. I hear its on sale this time of year.
I was going to say the same thing. Sometimes freezing works just as well as heat.
Might have to hit it with an air hammer along with the heat/freeze trick. You will need a new nut but thats cheap.
I have a Esab 1250 Plasma Cutter, it will make short work of getting the lockring off.
After the air hammer, you will need a new tube also.. Burp...burp... BUrp burp...
BURP.BURP.BURP...... Ahhh dam...
Little bit of skill goes a long way.
Little bit of skill goes a long way.
Dremel with a cut off wheel. Slice through the nut.
You don't even have to go all the way to the threads.
Just deep enough you can wedge a screwdriver in the slot and twist it to snap the ring.
Of course, you will need a new ring but thems' cheap.