I have been pouring a lot of boolits lately. Started using a .358 125 grain bullet mold I recently purchased from Midway. I was getting a lot of flash on the base of the bullet. After much work and much investigation, I realized the sprue plate was not flat. It was passed the 90 days, so Midway would not help. I contacted Lee and they told me the sprue plates are out sourced, but they would contact that company. In the mean time, they sent me 3 new sprue plates, because I told them 3 out of my 6 double cavity molds had bent sprue plates. Problem is all 3 of the new sprue plates were shaped like the bottom of a rocking chair. Lee wanted me to try them anyway. Those Lee molds are aluminum. Taking the steel screw out too many times has already damaged one mold. I told them if they could not send me flat sprue plates, I would modify them myself, or start buying RCBS or Lyman molds. Waiting to hear back from them. With a hammer and a vice, I was able to get one sprue plate flat, but that was a royal pain. Anyone else buy any Lee molds lately? Any problems?