And it's not the air flow sensor. I pulled the tubing off that. And the pilot wouldn't even light.
The switch has to make in the AFS. Pulling the tub int it.
Does the HSI glow brite trying to light the pilot...???
Sorry for the thread Jack Phylo.
And it's not the air flow sensor. I pulled the tubing off that. And the pilot wouldn't even light.
The switch has to make in the AFS. Pulling the tub int it.
Does the HSI glow brite trying to light the pilot...???
Sorry for the thread Jack Phylo.
No worries there, everyone needs heat
Pull the tubing. No spark at pilot.
Put the tubing back, pilot sparks and ignites.
So, since the switch is either open or close, I figure this proves it must be operating. or it would do the same thing under both circumstances.
I put one of these in my basement. It works great, and just an AA battery to light the pilot. It can be setup to run LP or NG out of the box.
https://www.menards.com/main/heatin...64-c-6867.htm?tid=-1450238802617871369&ipos=1